Epson Stylus Pro 11880 User Manual page 148

148 | Solving Problems
Message
PAPER JAM
REMOVE PAPER
PAPER OUT
LOAD PAPER
PAPER SENSOR ERROR
PRESS THE BUTTON
LOAD THE CORRECT PAPER
PAPER SENSOR ERROR
PRESS THE BUTTON
LOAD DIFFERENT PAPER
PAPER SETTING ERROR
CHECK PAPER SOURCE IN
THE DRIVER SETTINGS AND
LOAD PAPER CORRECTLY
PAPER SETTING ERROR
LOAD CUT SHEET PAPER
PAPER SETTING ERROR
LOAD ROLL PAPER
PAPER SIZE ERROR
LOAD CORRECT SIZE PAPER
PAPER SKEW
LOAD PAPER PROPERLY
PRINTER ERROR
RESTART THE PRINTER
REMOVE ROLL PAPER
RAISE THE PAPER SET LEVER
AND REMOVE PAPER
Explanation
Paper has jammed in the
printer.
Paper ran out or is not
ejected correctly.
The paper does not match
the media type selected
for auto head alignment.
The paper does not match
the media type selected
for head alignment.
The wrong paper source
(roll or sheet) is selected.
Roll paper is loaded, but
cut sheet is selected.
A sheet is loaded, but roll
paper is selected.
The size of the paper in the
printer doesn't match the
image size.
Paper is not loaded
straight.
You tried to print while an
error condition was
present.
Roll paper is not removed
from the printer.
6-148
Response
Release the paper lever and remove the
jammed paper; see page 156. Do you need to
turn the printer off and then back on?
Load paper. If paper is not ejected, release the
paper lever and remove the paper.
Press the Pause button, then load the right
paper (or change the media type selection).
Press the Pause button, then load the right
paper (or change the media type selection).
Check the Source setting in the printer driver
and make sure the paper is loaded correctly.
Make sure the setting matches the paper in the
printer, or load the correct paper. Press the
Pause button to start printing.
Make sure the setting matches the paper in the
printer, or load the correct paper. Press the
Pause button to start printing.
Make sure the size matches the paper in the
printer, or load the correct paper.
Release the lever and load the paper correctly.
Then return the lever to the locked position.
Press the P Power button to turn off the
printer. Wait 30 seconds, then turn it back on.
Release the paper lever and remove roll paper
from the printer.