Improving Print Quality - Epson Stylus Pro 11880 User Manual

Message
SERVICE CALL ERROR NNNN
TAKE-UP DISCONNECTED
SET AUTO TAKE-UP REEL
SYSTEM IN PRINTER AND
RESTART THE PRINTER
TAKE-UP ERROR
SET PAPER PROPERLY IN
AUTOMATIC TAKE-UP REEL
SYSTEM
TAKE-UP ERROR
IS ANYTHING OBSTRUCTING
THE TAKE-UP REEL SENSOR
SYSTEM? LOAD PAPER
AGAIN
Explanation
If 1133 or 1137 appear, the
print head may be locked.
If 3000 appears, the printer
is not plugged in correctly.
A serious error may have
occurred.
The auto take-up reel is not
installed.
Paper is not set up
correctly in the auto
take-up reel.
Something may be
obstructing the sensor.

Improving Print Quality

You can often improve print quality by doing the following:
Run a nozzle check and cleaning cycle. See page 122 for instructions.
•
Align the print head. See page 126 for instructions.
•
When you send a print job, make sure your print options are set
•
correctly. For more information, see Chapter 3 (Macintosh) or
Chapter 4 (Windows).
If none of these suggestions help, try the solutions on the following pages.
6-149
Solving Problems
Response
Remove the brackets securing the print head;
see page 31.
Turn the printer off. Unplug the printer and wait
30 seconds. Then plug it in corrctly and turn it
back on. Try turning the printer on and off a few
times. If the message remains, contact Epson
as described on page 10.
Install the auto take-up reel correctly. See
page 25.
Set up the paper correctly on the auto take-up
reel. See page 29.
Make sure nothing is obstructing the sensor
system. Set up the paper correctly on the auto
take-up reel. See page 29.
| 149