Mitsubishi Electric 800 Series Instruction Manual page 211

• To input the OH signal, set "7" in any parameter from Pr.178 to Pr.189 (Input terminal function selection) to assign the
function.
NOTE
• Changing the terminal assignment using Pr.178 to Pr.189 (Input terminal function selection) may affect the other functions.
Set parameters after confirming the function of each terminal.
Parameters referred to
Pr.71 Applied motorpage 304
Pr.72 PWM frequency selectionpage 153
Pr.178 to Pr.189 (Input terminal function
Pr.190 to Pr.196 (Output terminal function
210
10.(H) Protective Function Parameters
10.1 Motor overheat protection (electronic thermal O/L relay)
selection)page 292
selection)page 258