Trace Function - Mitsubishi Electric 800 Series Instruction Manual

14.12

Trace function

• The operating status of the inverter can be traced and temporarily stored in the RAM in the inverter. The data stored in the
RAM is deleted when the power supply is turned OFF. (The data is retained at inverter reset.)
• Stored data can be monitored by FR Configurator2, and the status of the inverter can be analyzed.
Pr. Name
1020
Trace operation selection
A900
1022
Sampling cycle
A902
1023
Number of analog channels
A903
1024
Sampling auto start
A904
1025
Trigger mode selection
A905
1026 Number of sampling before
A906 trigger
1027
Analog source selection (1ch) 201
A910
1028
Analog source selection (2ch) 202
A911
1029
Analog source selection (3ch) 203
A912
1030
Analog source selection (4ch) 204
A913
1031
Analog source selection (5ch) 205
A914
1032
Analog source selection (6ch) 206
A915
1033
Analog source selection (7ch) 207
A916
1034
Analog source selection (8ch) 208
A917
1035
Analog trigger channel
A918
1036 Analog trigger operation
A919 selection
1037
Analog trigger level
A920
Initial value Setting range
0
1
0
2
3
1, 2, 5, 10, 50,
1
100, 500, 1000
4 1 to 8
0
0
1
0
1
0 2
3
4
90% 0% to 100%
1 to 3, 5 to 14, 17,
18, 20, 23, 24,
32, 33, 40 to 42,
52 to 54, 61, 62,
67, 83, 91, 97,
201 to 210, 212,
213, 230 to 232,
*1
235 to 238
1 1 to 8
0
0
1
1000 600 to 1400
Description
Without trace operation
Sampling start
Forced trigger
Sampling stop
Set the sampling cycle.
1: 1 ms, 2: 2 ms, 5: 5 ms, 10: 10 ms, 50: 50 ms, 100: 100 ms,
500: 500 ms, 1000: 1 s
Select the number of analog channels for sampling.
Manual sampling start
Sampling starts automatically when the power supply is turned
ON or at a reset
Fault trigger
Analog trigger
Digital trigger
Analog or digital trigger (OR logic)
Both analog and digital triggers (AND logic)
Set the percentage of the pre-trigger sampling time with
respect to the overall sampling time.
Select the analog data (monitor item) for sampling on each
channel.
Select the analog channel to be the trigger.
Sampling starts when the value of the analog monitor exceeds
the value set at the trigger level (Pr.1037)
Sampling starts when the value of the analog monitor falls
below the value set at the trigger level (Pr.1037)
Set the level at which the analog trigger turns ON.
The trigger level is the value obtained by subtracting 1000 from
the set value.
14.(A) Application Parameters
11
12
13
14
15
16
17
18
19
20
377
14.12 Trace function