Advertisement
10. GAMMA SETTING TOOL PROCEDURES
10-1. OPERATING CONDITIONS OF THE GAMMA
SETTING TOOL
The operating conditions of the Gamma setting read tool of the
information display are as follows.
・Windows XP
・Windows Vista
・Windows 7
OS
(32bit Only)
An authorized copying and distribution
package of Microsoft Visual C++ 2005 or
later is required to be installed.
・ RS-232C port recognized as a COM port
Communication
(Which allows communication in 9600/
port
19200/ 38400bps.)
■When connected to the information display with an RS-232C
cable
The required RS-232C cable is as shown below. Connect the
PC's COM port and the RS-232C input terminal of the display with
the cable.
* The conversion cable for RS-232C connection is necessary.
Straight cable (D-SUB 9 pin female -
RS-232C cable
female)
RS-232 straight cable
(commercially available)
10-2.
SETTING
PROCEDURES
GAMMA SETTING TOOLL
■WHEN REPLACING THE PWB (WHEN THE PANEL IS NOT
CHANGED)
<BOOTING PROCEDURES OF THE GAMMA SETTING TOOL>
Press [Gamma] button of the service tool launcher.
<READING PROCEDURES OF THE SETTING>
PN-K321/K322B SERVICE MENU/VARIOUS SETTING TOOL OPERATING PROCEDURES 4 - 20
RS-232C input
terminal
PC
To COM port
WITH
THE
The reading procedures of the Gamma setting before
replacement by using the Gamma setting tool are as follows:
1) Press [Connection Setting] button and perform the
communication setting.
2) Turn ON the power of the information display.
3) Press [Read&Save] button.
4) When reading of all the setting contents is completed, the set
value is displayed and the dialog of saving the file is displayed.
The initial file name at that time is "[Model name]_[Serial
number]_[Date (YYYYMMDD)]." Check the file name and press
[Save] button to save the setting value.
5)Check to confirm that "K" mark is not displayed on the left upper
corner of the display. If "K" mark is displayed, perform the
reading procedure again.
6) Check to confirm that the Level value of the read setting
information is same as that shown in the above figure.
If the Level value of the read setting information differs from
that in the above figure, the setting data cannot be taken over.
In such a case, refer to [n WHEN REPLACING THE PANEL
OR WHEN THE OLD PWB DOES NOT OPERATE] and reset
the setting information to the default value. (Normally this does
not happen unless the value is individually changed.)
<WRITING THE GAMMA SETTING VALUE>
The writing procedures of the read setting value with the Gamma
setting tool after replacement of the PWB is as follow:
1 ) Press [Connection Setting] button and perform the
communication setting.
2 ) Turn ON the power of the information display.
3 ) Press [LoadFile...] button and select the setting file which was
saved.
4 ) Press [Write] button to write the setting value.
5 ) Check to confirm that "K" mark is not displayed on the left
upper corner of the display. If "K" mark is displayed, perform
the reading procedure again.
(CAUTION)
・ If the message of"This Monitor is not Support. Is write
processing continued?", "Writing data is not for this monitor. Is
write processing continued?", "Serial Number is different
between monitor and writing data.
Is write processing continued?", or "Model Name is different
between monitor and writing data. Is write processing
continued?" is displayed, the value to be written may be
different from the value of the read setting data. Check again
and perform writing again.
■WHEN REPLACING THE PANEL OR WHEN THE OLD PWB
Advertisement
