Advertisement
: '13/Dec
4-4. EXECUTION OF UPDATE
1) Insert USB flash drive to USB connector of monitor.
If USB flash drive is recognized, it will be displayed as follows.
Automatic upgrade will start in
XX S
MAIN1
：Ver X.XX -> Ver X.XX
MAIN2
：Ve rX.XX -> Ver X.XX
SUB
：Ver X.XX -> Ver X.XX
TPC1
：Ver X.XX -> Ver X.XX
TPC2
：Ver X.XX -> Ver X.XX
To cancel, remove USB flash drive
or press RETURN button.
EXECUTE...[ENTER] CANCEL...[RETURN]
* TPC1/TPC2 is displayed only on PN-K322B.
2)Check the contents. If no problem, Press [ENTER] button or
wait for the timeout for 30 seconds.
Press [RETURN] button or disconnect USB flash drive in order to
cancel.
3)The following messages will be displayed, if Enter is pushed or it
waits till the timeout.
4) Wait until the following completion message is
displayed.Display may be rebooted several times during this
process.
Finished updating software
The updated software is as follows.
MAIN１
：Ver X.XXX
MAIN２
：Ver X.XXX
SUB
：Ver X.XXX
TPC1
：Ver XXXX
TPC2
：Ver XXXXXXXX
4-5. IF UPDATE FAILS
(1) Turn OFF/ON the main power switch with USB flash drive
being inserted to the terminal.
(2) Just leave it.
(3) When the update is completed, the display will automatically
be turned OFF/ON. If the screen is not displayed during the
update, you can check if the data is read or not by seeing the
access lamp of USB flash.
4) If the update using USB flash cannot be performed, please
update with RS232C.
PN-K321/K322B
Be sure to update the sub firmware at first. Then, update the
main firmware.
Carry out the update of the sub firmware by following the normal
update procedure. On the other hand, carry out the update of
the main firmware by selecting the [BATCH2] button.
4-6. NOTES
- Do not store any files or folders other than this update data in
USB flash drive you use.
- USB memory with security feature cannot be used.
- If the filename is changed, the update will not be executed.
- If the version after rewriting is the same, the update will not start.
- Do not turn OFF the power or touch/remove USB flash drive
during the update.
END...[RETURN]
FIRMWARE UPDATA PROCEDURES 5-10
Advertisement
