Table of Contents
Advertisement
Chapter 2 Preparations
1.22.1 Installation
This section describes installation procedure for 2.5-inch hot-swap hard disk drives. Follow the same
installation procedure for 3.5-inch hot-swap hard disk drive.
1.
Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Locate the slot where you install the hard disk drive.
Install hard disk drives in ascending order of port number.
3.
Remove the dummy trays.
Dummy trays are installed in all slots.
4.
Unlock the handle of the drive carrier.
136
Note
In the RAID group (pack), build a Disk Array using hard disk drives that have the
same specifications (capacity, rotational speed, and standard).
Note
Keep the dummy trays for future use.
Express5800/T120e User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
