ABB AccessControl System Manual page 38

Fig. 25: Commissioning "Smart Access Point": Building type
3. Select the building type (system mode).
– Detailed information: see chapter 0 "Mode "Multi-unit house / commercial"" on page 36.
– Attention:
The building type can only be specified in the initial setup and it cannot be changed after
the initial setup.
If you want to change the building type, you need to reset the "Smart Access Point" to
the factory settings.
Fig. 26: Commissioning "Smart Access Point": Location
4. Enter the location.
– A time zone can be selected from a drop-down menu.
– This step can be skipped. During the later reconnection there is an automatic request for
an adjustment if the values between the PC and the "Smart Access Point" do not match.
System Manual 2CKA001473B5074
Commissioning
│38