Mounting/Dismounting Of Base Unit And Fan Unit; Mounting - Toshiba V Series User Manual

Chapter 2 Mounting, Dismounting & Cable Connection

2.1 Mounting/Dismounting of Base Unit and Fan Unit

2
2.1.1

Mounting

30
This section describes the method for mounting/dismounting a base unit and a fan unit.
• Do not touch rotary parts when power is applied; injury can be caused.
• Use a screwdriver suitable to M5 screws. Otherwise, screws can be damaged.
• The fan unit has an air inlet on the front panel. Secure a sufficient space in front of the fan
unit.
• Cooling air from the fan unit enters each module on the base unit from the bottom and is dis-
charged through the top. Therefore, secure a sufficient space on top of the modules
Mount a base unit/fan unit in the following procedure.
(1) Apply a fixing screw to each of four screw holes in the mounting bar of the console,
and temporarily tighten the screw by rotating it clockwise with a Phillips screwdriver.
Do not tighten the screw completely but leave two or three turns of thread.
(2) After confirming the vertical orientation of the base unit/fan unit, engage the base
unit/fan unit with the temporarily tightened screws by passing each screw head in
the larger section of each gourd-shaped mounting hole formed in the base unit/fan
unit.
(3) Tighten the four fixing screws completely to firmly secure the base unit/fan unit to the
mounting bar of the console.
1. Temporarily tighten the screw
(4 positions), leaving two or
three turns of thread.
Figure 2-1 Base Unit Mounting Procedure
WARNING
CAUTION
2. Pass the screw head in the
mounting hole (larger section)
for engagement with the unit.
3. Tighten the screw completely
(4 positions) to fix the unit.
Mount the fan unit in the same
method as above.
model 3000 Loop Controller L3 User's Manual - Basic Hardware -