Dismounting - Toshiba V Series User Manual

Chapter 2 Mounting, Dismounting & Cable Connection
2.2.2

Dismounting

2
34
All modules, including the power supply module, can be dismounted from the base unit
by the same method. Dismount each module in the following procedure.
(1) Remove each of two fixing screws (M4) at top and bottom of the module by rotating
it counterclockwise with a Phillips screwdriver.
• Make sure that all fixing screws have been removed. If the module is pulled off with any fix-
ing screw unremoved, the module can be damaged.
• After removing the fixing screws, be sure to dismount the module from the base unit immedi-
ately, and place it on a flat surface, such as a desk. If the module remains on the base unit
after removal of the fixing screws, it can fall off the base unit, causing injury.
(2) Dismount the module by pulling it slowly to the operator side, holding the upper and
lower portions of the module.
CAUTION
model 3000 Loop Controller L3 User's Manual - Basic Hardware -