Silvercrest SGS 600 A1 Operation And Safety Notes page 20

Safety notes
Do not stick metal objects (e.g.
needles, cables) into the steam
chamber. Do not block these.
Do not reach into or look directly
into the steam chamber while it
is in use. Scalding hazard.
CAUTION! RISK OF
BURNS DUE TO HOT
SURFACES! Please note, steam
will continue to escape from the
steam chamber for about a minute
after disconnecting from power.
CAUTION! RISK OF
BURNS DUE TO HOT
SURFACES! Please note that
the product housing becomes
hot during use.
Do not allow water to leak from
the device's steam chamber. Oth-
erwise hot water drops could spurt
out of the steam chamber during
next use. Scalding hazard.
Do not use the product outdoors
or in locations where aerosol
(spray) is used or pure oxygen
is administered.
Unplug from the socket when
adding water or cleaning the
product.
Only fill the water tank with puri-
fied, distilled or tap water.
Make sure the device does not get
wet when filling the water tank.
20 GB/IE
Do not attach or remove the water
tank during use. Allow the product
to cool down for approx. 10 min-
utes after use before touching the
water tank. Otherwise there is a
risk of burns.
Do not use extension cords.
Place the product on an even, level
surface. Never hold the product
in your hands during use. Scald-
ing hazard due to escaping water
or steam.
Fill the water tank
only (except for decalcification,
see chapter "Maintenance and
cleaning").
Keep a minimum distance of
25 cm from the steam chamber
during use, to prevent scalding.
Do not tip, shake or move the
product after use. Hot steam or
water could otherwise escape,
causing scalding. Allow the
product to cool down for approx.
10 minutes.
CAUTION! RISK OF
BURNS DUE TO HOT
SURFACES! This product must
not be used by persons insensi-
tive to heat and other vulnerable
persons who do not respond to
overheating (e.g. diabetics, per-
sons with skin changes caused
by illness or scarred skin areas
with water
1