Table of Contents
Advertisement
4 SAFETY MONITORING FUNCTIONS
SPPFMG parameter is available with software version of each device shown in the following table.
Controller
RT ToolBox3/RT ToolBox3 Pro
(simulation function)
Caution
Caution
4-62 Safety Monitoring Functions
When the
margin is set
Fig. 4-55: SLP prior stop when the margin is set
Table 4-12: Software version that supports SPPFMG parameter
Device
When a large value (for example, a value larger than the distance between the current
position and the safeguarded space) is set in SPPFMG parameter, the robot will enter
the SLP prior stop state immediately after the robot starts moving and its movement is
restricted. Set SPPFMG parameter appropriately.
Check state variable M_SlpPreStp to see whether the robot is in the SLP prior stop state.
When the simulation function of RT ToolBox3 or RT ToolBox3 Pro is used, setting
SPPFMG parameter to a value larger than the distance between the robot position at the
start of the simulation and the safeguarded space will cause error H220m at startup of
the simulation. In this case, change the SPPFMG parameter setting or the SLP monitoring
settings.
Safeguarded
Initial state
SPPFMG
Compatible version
Ver. C2 or later
Ver. 1.90U or later
space
Advertisement
Table of Contents
