Hitachi BD-D120XGV Instruction Manual page 44

How to use the Washer Dryer (Continue)
How to use the Auto Self Clean function
1. Press the Power button to turn on the power.
2. Select a program.
3. Press the Auto Self Clean button, and then press the Start/Pause button.
■
The setting is switched off at the time of shipment from the factory.
Once it is switched on, the Auto Self Clean function operates every time you do your laundry.
■
Prior to the final spin cycle, the outside of the tub, and the inside of the outer tub are washed to
eliminate dirt and mold.
■
To deactivate the Auto Self Clean function, press the Auto Self Clean button again while the power is on.
● The Auto Self Clean function runs just before the spin cycle begins in each program.
● The Auto Self Clean function cannot be set or canceled while the washer dryer is operating.
● The Auto Self Clean function is automatically canceled when:
– Rinse Hold is set.
– No spinning is set.
● Depending on the type and degree of dirt, some dirt may not be removed by using the Auto Self
Clean function.
● If the washer dryer is seldom used, some dirt may not be removed by using the Auto Self Clean
function.
● To clean the tub more completely, we recommend using the Tub Wash program along with the
Auto Self Clean function.
■
The Auto Self Clean function is deactivated if one of the following programs is selected.
Page 36-39 : Program Overview
How to use the Memory function
1. Press the Power button to turn on the power.
2. Select and adjust the program as desired.
3. Press the Memory button, then the setting is memorized.
4. Press the Start/Pause button.
■
Once the setting is saved, the customized program can be selected with just a press of the Memory
button.
■
Customized program can be changed by doing the same procedure.
44