Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips # 1 screwdriver
● Small flat blade screwdriver
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Side cover
Wireless card
M.2 2230/2280 Solid-state
drive
Riser card bracket
Optional I/O modules
Heat sink
System board
10
Removing and installing components
Screw type
#6-32 (Thumbscrew)
M2x3
M2x3.5
M3x5
M3x3
Captive screws
M3x4
Quantity
1
2
1+1 (for slot1 and slot2)
2
2
3
5
Screw image
2