Philips 8000 Series User Manual page 19

» Determine the status based on
the wireless subwoofer indicator.
LED State
Fast blink
Slow blink
Constant on
Tips
•
Do not press Pair button on the rear of the
subwoofer, except for manual pairing.
Manual Pairing
If no audio from the wireless subwoofer
can be heard, manually pair up the
subwoofer.
1
Both soundbar and subwoofer are on.
2
Press and hold (5 seconds) the Pair
button on subwoofer until the
subwoofer Red LED blink.
3
Press and hold soundbar local keys
Play/Pause and Vol+ for 3 seconds.
4
The soundbar will discover and pair
with the subwoofer in pairing mode.
» Main unit and subwoofer
shall discover each other and
pair, main unit display shows
"PAIRING".
» If pairing succeeds, main unit
display shows "SUBWOOFER
PAIRED" for 3 seconds.
Status
Subwoofer in pairing mode
Pairing Failed
Connected / Pairing successful
» If pairing fails, main unit display
shows "CHECK SUBWOOFER" for
3 seconds. If Soundbar cannot
know which device type has
failed to pair, main unit will show
"CHECK DEVICE" for 3 seconds.
When performing manual pairing, the
soundbar must be on. Pairing can only
be done one device per time. Refer
to Wireless Subwoofer and Wireless
Surround Speakers sections for details.
Tips
•
The subwoofer should be within 6 m of the
Soundbar in an open area (the closer the
better).
•
Remove any objects between the subwoofer
and the Soundbar.
•
If the wireless connection fails again, check if
there is a conflict or strong interference (e. g.
interference from an electronic device) around
the location. Remove these conflicts or strong
interferences and repeat the above procedures.
19 EN