NEC Express5800 User Manual page 34

2-10 General Description
STATUS Lamp
The STATUS lamp stays lit in green when the CPU blade is in successful operation. When the
STATUS lamp is flashing in amber or red, it indicates that the system has failed.
In addition, you can view the detailed information on error message on virtual LCD when the
STATUS lamp is flashing in amber or red.
You can use the virtual LCD through the Web browser of EXPRESSSCOPE engine (BMC) or NEC
DianaScope Manager.
The following table lists indications of the STATUS lamp, descriptions, and actions to take.
If an error occurs, contact your service representative.
NOTE:
Maintenance Utility installed, you can view the System Event Log
(SEL) to identify the cause of a trouble.
STATUS lamp
Status Color
On Green
Off –
On Red
Flash Red
Flash Amber
NOTE:
flashing in amber or red, the indication of the STATUS lamp is retained
except for certain factors. When the CPU blade is powered on, the
STATUS lamp goes on green (normal status).
If the CPU blade has the NEC ESMPRO or Off-line
STATUS lamp indications
Description
The CPU blade is operating
normally.
The power is turned off.
BMC is being initialized.
See the table "Virtual LCD indications when STATUS lamp is flashing in
red" described later.
See the table "Virtual LCD indications when STATUS lamp is flashing in
amber" described later.
If the CPU blade is powered off while the STATUS lamp is
Action
–
Turn on the power.
1. Wait until the lamp goes off.
2. If the lamp still goes on, check
installation of the CPU blade.