Installing The Hard Disk Drives; Enabling Raid Feature; Lsi Logic Software Raid Setup Utility - NEC Express5800 User Manual

Installing the Hard Disk Drives

Install two hard disk drives to your CPU blade. See Chapter 9 for detail.
IMPORTANT:
addition, use two hard disk drives of the same capacity if you are going
to configure RAID1.

Enabling RAID Feature

You can use the two hard disk drives as a single disk drive or RAID drives. To configure a hard disk
drive as RAID drive, run SETUP utility and select [Advanced] - [PCI Configuration] - [Embedded
SCSI] - [RAID Enable] - [Enabled]. See Chapter 4 for details.
NOTE:
drive.

LSI Logic Software RAID Setup Utility

The configuration tool used for on-board RAID controller (LSI Logic Embedded MegaRAID) is
"LSI Logic Software RAID Setup Utility".
NOTE:
on remote console feature of NEC Dianascope.
Running the Utility
1.
When the following screen appears after you have powered on the CPU blade, press Esc.
The POST screen appears.
Use two hard disk drives of the same revolution. In
The factory-set value is to use the hard disk drive as a RAID
The LSI Logic Software RAID Setup Utility cannot be used
Configuring Your Server 4-29