NEC Express5800 User Manual page 88

4-38 Configuring Your Server
Others
1.
Clear Configuration
Clears configuration information. Select [Configure] → [Clear Configuration] from the
TOP menu. Executing [Clear Configuration] clears all configuration information on the
disk array controller and hard disk drives. The configuration information on all channels
of the disk array controller is also cleared.
NOTE:
and that on the hard disk drive do not match (excluding at replacement
of faulty disk array controller), configuration may fail if you select the
configuration information on the disk array controller. In this case,
execute [Clear Configuration] to create configuration again.
2.
Force Online
Puts a hard disk drive being in the FAIL status online.
Select [Objects] → [Physical Drive] → (select hard disk drive) → [Force Online] from the
TOP menu.
3.
Rebuild Rate
Sets the Rebuild Rate.
Select [Objects] → [Adapter] → [Sel. Adapter] → [Rebuild Rate] from the TOP menu.
Available value is between 0% and 100%. Default value (recommended) is 30%.
4.
Hard disk drive information
Checks hard disk drive information.
Select [Objects] → [Physical Drive] → (select hard disk drive) → [View Drive
Information] from the TOP menu.
When configuration information on the disk array controller