Panasonic NA-D106X1 WS3 Operating & Installation Instructions Manual page 27

Installation
Water tap adaptor and water supply hose
 Mains water pressure and water fl ow
 Water pressure: 0.03-1.0 MPa
If the water pressure exceeds this value, attach a
pressure reducing valve.
 Water fl ow from tap: 5 L/min. or more
 Connecting the water supply hose
CAUTION
 Do NOT twist, squash, modify or cut the hose.
Tighten the nut fi rmly.

1
Connect the water tap adaptor
to the water faucet.
1 Turn part A to the left until approx. 4 mm of
the thread becomes visible.
2 Loosen the 4 screws.
3 Connect to the faucet and tighten the
screws.
4 Turn part A to the right and tighten securely.
(To prevent water leakage)
2
Connect the water supply hose
to the water tap adaptor.
Insert the hose into the adaptor while pushing
down the lever, and hook the claw of the lever
on the fl ange of the adaptor.
Screw
Part A
Flange
Thread
Claw
Lever
52
(continued)
3
Connect the water supply hose
to the water inlet.
Attach the end of the hose to the water inlet of
the appliance and tighten the nut.
Water supply
hose
Water inlet
Drain hose
 Draining to a sink or wash basin
CAUTION
Secure the drain hose with an elbow so that it does
not come off due to water pressure during drainage.
Elbow
(supplied)
 Draining to a stand pipe
Stand pipe
 Draining to a drain outlet
Note
Do not twist, pull out or bend the drain hose.

Do not put the hose tip under water.

5. Levelling the appliance
Check the horizontal state.
Look at the leveller. Adjust the tilt.
No adjustment
Horizontal
needed.
Lower the right
Right side
side or raise
higher
the left side.
Lower the left
Left side
side or raise
higher
the right side.
Raise the front
Rear side
side.
higher
(2 locations)
Lower the front
Front side
side.
higher
(2 locations)
How to check rattling
Push the diagonal corners alternately and
confi rm there is no rattling.
If the appliance rattles, adjust the height of
the legs and check the leveller.
* 2 adjustable feet
are attached at
the front side.
How to adjust the tilt
Loosen
(1) Turn to to
loosen.
(2) Raise or lower to
adjust the tilt.
(3) Turn to Tighten to
To raise
fi x.
To prevent
abnormal
vibration
Leveller
(1)
(3)
Loosen
Tighten
(2) (2) (2)
Knob
To lower
Adjustable feet
53