Table of Contents
Advertisement
5.
While holding up the display, disconnect the following cables from the system board:
(1) Touch cable (ZIF connector)
(2) Display LVDS cable (reverse ZIF connector)
6.
If you need to replace the display cables, disconnect touch cable from the ZIF connector on the back of
the display panel (1). Lift the tape and disconnect the LVDS display cable from the back of the display
panel (2).
Reverse this procedure to replace the display assembly. Run the camera function test after the repair. For
more information, see
Touch control board
To remove the touch control board, use this procedure and illustration.
32
Chapter 5 Removal and replacement procedures for authorized service provider parts
Basic camera function test on page
30.
Advertisement
Table of Contents
