Battery - HP 11-be0 Series Maintenance And Service Manual

3. Disconnect the battery cable from the system board (see
4. Remove the system board (see
Remove the camera:
1. Remove the two Phillips M2.0 × 3.0 screws from the camera module brackets (1).
2. Remove the two Phillips M1.0 × 3.0 screws from the motor (2).
3. Remove the brackets from the computer (3).
4. Remove the motor (4).
5. Pull the camera module up through the hole to remove it (5).
Reverse this procedure to install the camera. Run the camera function test after the repair. For more
information, see

Battery

To remove the battery, use these procedures and illustrations.
Table 5-13 Battery description and part number
Description
Battery (2 cell, 32 Whr, 4.18 Ah)
Battery adhesive
44 Chapter 5 Removal and replacement procedures for authorized service provider parts
System board on page
Basic camera function test on page
Battery on page
39).
30.
44).
Spare part number
M75108-006
M98024-001