2.
Remove the board from the computer (2). The board is secured with adhesive.
To replace the BIOS board, reverse the removal procedures. Run the camera function test after the repair. For
more information, see
Pogo connectors and cables
The computer includes two different pogo connectors so that the user can connect a keyboard and orient the
display in either portrait or landscape mode. To remove the pogo connectors and cables, use these
procedures and illustrations.
Table 5-8
Pogo connector and cable description and part number
Description
Pogo connector and cable (bottom, portrait)
Pogo connector and cable (right, landscape)
Before removing the pogo connectors and cables, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the display assembly (see
3.
Disconnect the battery cable from the system board (see
Remove the pogo connectors and cables:
1.
Disconnect the pogo cable from the ZIF connector on the system board (1).
2.
Remove the two Phillips M2.0 × 2.0 screws (2) that secure the pogo connector to the computer.
Basic camera function test on page
Display assembly on page
30.
Preparation for disassembly on page
30).
Battery on page
Component replacement procedures
Spare part number
M93509-001
M93510-001
29).
44).
37