NEC Express5800 Series Maintenance Manual page 48

Chapter 1 Maintenance
8. System Diagnostics
3. Select End-User Mode to start System Diagnostics. This process takes about three minutes.
When the diagnostics is completed, the screen display changes as shown below.
For details of [End-User Mode (Professional)], refer to the file "eupro_ug_en.pdf" in \isolinux\diag folder
stored in EXPRESSBUILDER.
Diagnostics tool title
Test window title
Test results
Test summary window
Guideline
Diagnostics tool title
Shows the name and version of the diagnostic tool.
Test window title
Shows the progress of the diagnostics. "Test End" is displayed when the diagnostics completes.
Test results
Shows the start, end, and elapsed time and completion status of the diagnostics.
Guideline
Shows the details of the keys to operate window.
Test summary window
Shows the results of each test that executed the diagnostics. Move the cursor and press <Enter> key on
the cursor line to display the details of the test.
When an error is detected by the System Diagnostics, the relevant test result in the Test summary
window is highlighted in red, and "Abnormal End" is displayed in the result on the right side.
Move the cursor to the test that detected the error, and press <Enter > key. Take notes about the error
message that has been output to the Detail Information screen and contact the store where you
purchased the product or your maintenance service company.
48
Express5800/E120e-M Maintenance Guide