NEC Express5800 Series Maintenance Manual page 70

Chapter 2 Useful Features
For details about the options, see the table below.
Option
Serial Port A Settings
Serial Port A
Serial A Base I/O
Serial A Interrupt
Serial Port B Settings
Serial Port B
Serial B Base I/O
Serial B Interrupt
Console Redirection Settings
BIOS Redirection Port
Terminal Type
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
Continue C.R. after POST
70
Parameter
– –
Disabled Enable or disable serial Port A.
[Enabled]
[3F8h] Specify the base I/O address for serial port A.
2F8h
3E8h
2E8h
[IRQ 4] Specify the interrupt for serial port A.
IRQ 3
– –
Disabled Enable or disable serial Port B.
[Enabled]
3F8h Specify the base I/O address for serial port B.
[2F8h]
3E8h
2E8h
IRQ 4 Specify the interrupt for serial port B.
[IRQ 3]
– –
[Disabled] Enable or disable the console redirection feature for the
specified serial port. Specifying [Serial Port A] or [Serial
Serial Port A
Port B] allows direct connection via terminal unit. Options
Serial Port B
for connection shown below are displayed.
[VT100+] Select the terminal type.
VT-UTF8
PC-ANSI
9600 Specify baud rate.
19200
57600
[115200]
7 Specify data bit width.
[8]
[None] Specify parity type.
Even
Odd
[1] Specify stop bits.
2
None Specify the flow control method.
[Hardware RTS/CTS]
Disabled Select whether the console redirection is continued after
completion of POST or not.
[Enabled]
Express5800/E120e-M Maintenance Guide
Descriptions
[ ]: Factory settings
1. System BIOS