Mitsubishi Electric KD Series User Manual page 53

3-2-1 Preparation by users
③ CoaXPress® cable
CIS (This product) has DIN1.0 / 2.3 connectors.
Check the connectors of Grabber board (DIN1.0 / 2.3 or
BNC) and prepare the connectable cables.
④ Frame grabber board
Prepare Frame Grabber board (or PC with Grabber board
installed) supporting CoaXPress® .
【Remarks】
CIS does not support PoCXP. Set the Frame Grabber
board settings as NOT to supply +24V power to the
CoaXpress® cable.
TM-XH719C
3-2 Preparation
CoaXpress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
⑤ DC5V power
Supply more than the current capacity listed in below.
（Not needed when using Power Supply unit)
No. Configuration
KD-CX series
1 KD-CX-NL series
Non Optional PSU
⑥ DC24V power
Supply more than the current capacity listed in below.
No. Configuration
KD-CX series
1
Non Optional PSU
※Refer to the following configuration, when you use
Power Supply Unit.
No. Configuration
KD-CX series
2
With Optional PSU
KD-CX-NL series
3
With Optional PSU
Current capacity (A)
L1 L2 L3
10 15 20
Current capacity (A)
L1 L2 L3
2.8 4 5
Current capacity (A)
L1 L2 L3
5 7.5 9.5
2.2 3.5 4.5
53