Mitsubishi Electric KD Series User Manual page 64

3-3-4 CX-NL series LED control signal output
(This cable is not included in the CIS product)
Non-illumination type CIS (CX-NL series) outputs a trigger
signal from connector L1, that is used to synchronize the
output of this product with an external illumination. When
using this trigger signal for the external illumination control,
connect ⑦External illumination control cable to the
connector L1.
2) Fix CIS connectors and the cable by screws
CIS has locknut D20418-J3R (JAE) (M2.6, female).
Use M2.6 screw, M2.5 screw, M2.6 type JAE Lock screw,
etc., which are applicable to fasten cable connectors.
Recommended tightening torque is 16 - 20 N*cm.
TM-XH719C
3-3 Connections
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
【Remarks】
1) Do not screw with higher torque than recommended.
Otherwise, locknut on CIS may be loosened or removed, when
you remove screws.
2) CIS does not support hot-swap.
Make sure to power off CIS before connecting / removing
cables. If the cables are connected / removed while
powered on, it may cause failure on CIS.
64