Mitsubishi Electric KD Series User Manual page 61

3-3-1 Connections
4）KD-CX-NL series (With Optional PSU)
KD6R367CX-NL
V1
L1
D1◎
D2
D3
D4
KD6R587CX-NL,
KD6R807CX-NL
V1
L1
V3
D1◎
D2
D3
D4
D5●
D6
D7
D8
* ◎：Master port
* ●：Slave port
TM-XH719C
3-3 Connections
⑩CIS-Optional PSU cable DC5V
⑦External illumination control cable
③ CoaXPress® cable
③ CoaXPress® cable
③ CoaXPress® cable
③ CoaXPress® cable
⑩CIS-Optional PSU cable DC5V
⑦External illumination control cable
⑩CIS-Optional PSU cable DC5V
③ CoaXPress® cable
③ CoaXPress® cable
③ CoaXPress® cable
③ CoaXPress® cable
③ CoaXPress® cable
③ CoaXPress® cable
③ CoaXPress® cable
③ CoaXPress® cable
【Remarks】 When you use several Grabber boards, the external sync signal can be provided only
through Master port. Remark when changing Grabber board settings.
CoaXpress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
⑧Optional PSU
⑨DC24V cable for
KDCX24VPW
To external illumination
Port 1
<Grabber board 1>
Port 2
Port 3
Port 4
④ Frame Grabber board
⑧Optional PSU
⑨DC24V cable for
KDCX24VPW
To external illumination
⑧Optional PSU
⑨DC24V cable for
KDCX24VPW
Port 1
<Grabber board 1>
Port 2
Port 3
Port 4
④Frame Grabber board ×２
Port 1
<Grabber board 2>
Port 2
Port 3
Port 4
⑥ DC24V
Optional PSU
power
⑥ DC24V
Optional PSU
power
Optional PSU
【Remarks】
If you supply voltage from
several power sources,
use the common GND.
61