Setting(Others): Test Pattern - Mitsubishi Electric KD Series User Manual

Address Register name
6020 TestImageSelector
6024 TestLineRate
6028 TriggerMode
5-2-18 Test pattern
[Function]
Output a test pattern over CoaXpress® in order to make
sure image data communication from CIS to frame grabber.
Please use this function when you setup your system.
1) Grey ramp horizontal
2) Grey ramp vertical
TM-XH719C

5-2 Setting(others): Test pattern

R/W Val
R/W 0 to 3
R/W 0 to 55000
R/W 0 or 1
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
Set test pattern
0:OFF /1:Grey ramp horizontal
2:Grey ramp vertical
Set line rate for test pattern
�������� ��������[����] = (register value)
Set source of sync signal
0:Internal sync mode, 1: External sync mode
3) RGBW
[Remark]
1) When you use this function based on Internal sync
mode, you need to set Line rate and to switch the
setting of "TriggerMode" to be "010". After running
a sequence of "010" at "TriggerMode" , Test pattern
starts output.(When using External sync mode, this
sequence is not necessary.)
2) The purpose of this function is to make sure if the data
transfer is appropriated operated. When you use this
function, the image data is not output.
3) After using Test pattern function, please run Device
discovery process again in order to restart scanning.
(Before Device discovery, some defective images
output.)
CoaXPress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
Result
/3:RGBW
Initial
0
55000
0
89