Installing In Blade Enclosure - NEC Express5800 Series User Manual

Installing in Blade Enclosure

To use the Tape Blade, install it in a Blade Enclosure.
This section describes how to install the Tape Blade in SIGMABLADE-M, as an example.
Installation
1.
Locate a slot to install Tape Blade according to "Installation Order" described earlier.
2.
If the CPU blade has already been installed, power off the CPU blade.
IMPORTANT:
of CPU blade being on.
3.
If a blank cover is installed on the slot on which the Tape Blade is to be installed, unlock it
by holding the lever on the front face, and remove the blank cover.
IMPORTANT:
Keep the removed blank cover for future use.
Do not remove the blank cover from any other slot than the target
slot.
You cannot install/remove Tape Blade with the power
Setting Up Your Tape Blade
3-5