Ejecting The Data Cartridge - NEC Express5800 Series User Manual

Ejecting the Data Cartridge

1.
Ensure that the Tape Blade is powered-on.
2. Press the eject button. The drive rewinds the tape and partially ejects the
cartridge. The eject cycle will take a few minute.
IMPORTANT:
software, the Tape Blade rewinds the tape, but does not eject a cartridge.
In this case, make sure that the LTO is ready to eject a cartridge (the
status LED blinks twice and repeats that cycle). Then, press the Eject
button to eject a cartridge.
3.
After the cartridge partially ejects, grasp the cartridge and remove it.
IMPORTANT:
When the status LED is blinking, do not turn off the server. This
may cause a malfunction or damage data.
To avoid a malfunction, do not transport this drive with the data
cartridge installed.
Eject the data cartridge upon completion of backup process.
If the cartridge eject command is issued by the backup
Upgrading Your Tape Blade
9-13