Starting Sas Configuration Utility; Exiting Sas Configuration Utility - NEC Express5800 Series User Manual

4-4
Configuring Your Tape Blade

Starting SAS Configuration Utility

Follow these steps to start SAS Configuration Utility.
9.
Turn on the computer.
The following message will be displayed.
LSI Corporation MPT SAS BIOS
MPTBIOS-6.22.00.00 (2008.04.10)
Copyright 2000-2008 LSI Corporation.
Press Ctrl-C to start LSI Logic Configuration Utility...
10.
Hold <Ctrl> key and press <C> key.
SAS Configuration Utility starts and the "Adapter List" menu will be displayed.

Exiting SAS Configuration Utility

Follow these steps to exit SAS Configuration Utility.
1.
If you changed any settings, you are prompted to save the changes before you exit.
At the prompt, select the item which you want, press <Enter> key.
xxxxxxxx xxxxxxxx changes have been made.
Cancel Exit
Save changes then exit this menu
Discard changes then exit this menu
Exit the Configuration Utility and Reboot
2.
At "Adapter list" menu, press <ESC> key until a message prompts you to exit
At the prompt, select the item which you want, press <Enter> key.
Are you sure you want to exit?
Cancel Exit
Save changes and reboot.
Discard changes and reboot.
Exit the Configuration Utility and Reboot
Any changes made in SAS Configuration Utility will take effect the next time the
computer is rebooted.