Basic Communication Procedure - Mitsubishi Electric MELFA CR800-D Series Instruction Manual

7. Basic Communication Procedure

This chapter describes the operations from creating a master station's CC-Link program to establishing a
communication by running the sample ladder program provided with this product, using a system configured
with one CC-Link interface card connected to one PLC master station module (one-to-one connection).
The sample ladder program provided starts up robot program No. 1.
* For information about communication via the personal computer CC-Link interface board, refer to the
instruction manual of the personal computer CC-Link interface board.
Setting the parameter of CC-Link master station ...............
Setting the parameter of robot controller ...........................
Creating a master station CC-Link program ......................
Creating robot program No. 1 ............................................
Running robot program No. 1 ............................................
↓
↓
↓
↓
7.1
See section
7.2
See section
7.3
See section
7.4
See section
7.5
See section
29
Setting the parameter of CC-Link
master station
Set the parameter of the robot
controller
Creating a Master Station CC-Link
Program
Create the robot program No. 1
Start the robot program No. 1 from the
master station