Mitsubishi Electric MELFA CR800-D Series Instruction Manual page 7

■Revision History
Print date
2008-08-08
2009-06-15
2011-12-27
2012-03-13
2012-04-11
2012-11-27
2013-12-20
2016-08-08
2017-05-31
2018-02-01
Instruction manual No.
BFP-A8701
BFP-A8701-A
BFP-A8701-B
BFP-A8701-C
BFP-A8701-D
BFP-A8701-E
BFP-A8701-F
BFP-A8701-G
BFP-A8701-H
BFP-A8701-J
Revision content
･ First print
･ (Notes) were added in Introduction.
･ The robot system variables (M_In8,M_In16,M_Out8 and
M_Out16) were added.
･ Dip switch SW1 explanation was added.
･ CR751-D/CR750-D was added.
･ The supplement about CR751-D/CR750-D was added.
(Introduction, Table 3.1 1)
･ The error in writing was corrected.
･ Notes about transmission delay time were added to the
communication cable.
･ The signal table was corrected. (Error in writing)
･ A terminator was added.
･ An explanation was added to parameter CCERR.
･ The cover and corporate logo mark of this manual was
changed.
･ 7.4 chapter was corrected. (Error in writing)
･ The CR800-D series controller was added.
･ Safety Precautions was revised. (The CR800-Q controller
was added.)