Yamaha MT-09 2021 Service Manual page 13

The QS functions can be turned on or off in the
setting MENU.
TIP
The upshift and downshift functions are inde-
pendent and can be activated separately.
For more information on the QS system.
Setting menu icon "
Choose this icon and push the wheel switch to
change the settings MENU screen.
Grip warmer indicator (Option)
The grip warmers can be used when the engine
is running. There are 10 temperature levels.
When activated, the indicator will display the
temperature level from 1 (lowest) to 10 (highest).
To activate the grip warmer, use the wheel
switch to highlight the grip warmer display with
the cursor.
Press the wheel switch inward to select the grip
warmer function.
Once selected, rotate the wheel switch up and
down to adjust the temperature level.
Press the wheel switch inward to confirm the
temperature level and exit the grip warmer func-
tion.
ECA17932
NOTICE
• Be sure to wear gloves when using the grip
warmers.
• Do not use the grip warmers in warm
weather.
• If the handlebar grip or throttle grip be-
comes worn or damaged, stop using the
grip warmers and replace the grips.
The function of the wheel switch can be locked
into grip warmer mode by pressing and holding
the wheel switch inward while the grip warmer
indicator is highlighted by the cursor.
In this mode, the temperature levels can be in-
stantly adjusted by rotating the wheel switch up/
down.
To exit this mode and return the wheel switch to
its normal functionality, press and hold the wheel
switch inward.
TIP
The current grip warmer setting is saved when
the vehicle is turned off.
"
Lap timer
This stopwatch function can be activated
through the setting MENU.
Once activated, the vehicle information display
is replaced with:
1
1. Lap count
2. Current lap time
3. Latest/Previous lap time
To start the timer, press the pass switch.
Each press of the pass switch will increase the
lap count by 1 and reset the current lap timer.
To pause the lap timer, press the wheel switch
inward.
To unpause the timer, press the pass switch and
the timer will resume without counting a new lap.
To exit the lap time mode, turn it off in the set-
tings MENU.
TIP
• The engine must be running to start the lap tim-
er.
• The headlights will flash when the pass switch
is pressed.
• Whenever the lap timer is paused, it can be re-
sumed using the pass switch.
Brake control icon "BC"
This icon is replaced by the auxiliary system
warning and coolant temperature warning indi-
cators when they are activated.
Error mode warning "Err"
When an internal error occurs (e.g., communica-
tion with a system controller has been cut off),
the error mode warning will appear as follows.
"Err" and " " indicator light indicates an ECU
error.
"Err" only indicates an ABS ECU error.
1-4
FEATURES
2
0 0 : 1 2 . 3 4
02
LAP
3
0 0 : 0 1 . 2 3
LATEST