Yamaha MT-09 2021 Service Manual page 67

1. Crankshaft position sensor coupler
2. Rear brake light switch lead
3. Rear wheel sensor lead
4. Rear wheel sensor coupler
5. Wire harness (to joint coupler)
6. Wire harness (to ABS ECU)
7. Wire harness (to radiator fan motor relay)
8. Radiator fan motor relay
9. Wire harness
10. Clamp
11. Battery box
12. Starter motor lead
A. Pass the crankshaft position sensor lead
beneath the wire harness (to stator coil
assembly) and connect the crankshaft posi-
tion sensor coupler on the right side of the
vehicle.
B. Route the rear brake light switch lead on the
rear side of the wire harness (to rectifier/reg-
ulator).
C. Route the rear wheel sensor lead on the rear
side of the wire harness (to rectifier/regula-
tor).
D. Route the rear wheel sensor lead on the top
side of the wire harness.
E. Route the wire harness (to radiator fan motor
relay) on the rear side of the wire harness
(to ABS ECU) and wire harness (to joint cou-
pler).
F. Route the rear brake light switch lead on the
top side of the wire harness.
G. Route the wire harness (to radiator fan motor
relay) on the front side of the clamp.
H. Route the wire harness (to radiator fan motor
relay) on the lower side of the wire harness.
Route the wire harness (to radiator fan motor
relay) on the top side of the starter motor
lead.
I. Top of the vehicle
2-40
CABLE ROUTING