Yamaha MT-09 2021 Service Manual page 73

1. Brake hose (hydraulic unit to front brake cali-
per (left))
2. Brake hose (front brake master cylinder to
hydraulic unit)
3. Meter assembly bracket
4. Front fork
5. Front brake caliper assembly (right)
6. Front fender
7. Clamp
8. Bracket
9. Frame
10. Brake hose joint
11. Front wheel sensor lead
12. Brake hose (front brake caliper (left) to front
brake caliper (right))
A. Fit the metal fitting for the front brake hose to
the recess of the brake hose joint.
B. Install the brake hose between the stoppers
on the brake hose joint.
C. Insert the clamp into the hole of the bracket
of meter assembly.
D. Make sure the clamp is engaged by 2 or
more notches. Engage the claws so that they
face toward the right of the vehicle.
E. Insert the grommet of the front wheel sensor
lead.
F. Fit the clamp between the ribs on the front
fender.
G. Make sure the clamp is engaged by 2 or
more notches. Engage the claws so that they
face toward the rear of the vehicle.
H. Insert the clamp into the hole of the front
fender.
I. After holding the protrusion (17 mm (0.67 in)
on the brake hose joint with an appropriate
tool, tighten the brake hose union bolts to the
specified torque.
2-46
CABLE ROUTING