Yamaha MT-09 2021 Service Manual page 85

1. Front turn signal light lead (left)
2. Radiator
3. Radiator outlet hose
4. Thermostat assembly
5. Front turn signal light lead (right)
6. Radiator cap
7. Coolant reservoir hose
8. Water jacket joint
9. Radiator inlet hose
A. Face the tip of the clip toward the yellow paint
mark on the radiator outlet hose.
B. Align the yellow paint mark on the radiator
outlet hose with the rib on the thermostat
assembly.
C. Insert the radiator outlet hose until it touches
the rib of the thermostat assembly.
D. Install the radiator hose (cylinder head to
radiator) with its white paint mark facing for-
ward.
E. Install the radiator hose (cylinder head to
radiator) up to the base of the bend in the
radiator pipe.
F. Install the clip with its end facing the down.
G. Insert the coolant reservoir hose up to the
section where the radiator pipe increases in
diameter.
H. Fit the clip with its end facing inward. Fit the
clip in the center between the spools, never
ride on the spool.
I. Insert the radiator inlet hose until it touches
the rib of the water jacket joint.
J. Align the yellow paint mark on the radiator
inlet hose with the rib on the water jacket
joint.
K. Install the hose clamp screw to face it top
side.
L. Install the hose clamp with the screw head
facing the inward.
M. Install the radiator inlet hose with its white
paint mark facing outward.
N. Insert the radiator inlet hose up to the section
where the fuel tank pipe increases in diame-
ter.
O. Insert the radiator outlet hose up to the sec-
tion where the fuel tank pipe increases in
diameter.
P. Install the radiator outlet hose with its white
paint mark facing outward.
Q. Hose clamp fixed position details.
R. 3 mm (0.12 in) or more
S. 0–1 mm (0–0.04 in)
T. Hose plug-in section
U. Make sure not to install the hose clamp on
the raised portion of the hose fitting.
V. Hose clip fixed position details.
W. Make sure not to install the hose clip on the
raised portion of the hose fitting.
2-58
CABLE ROUTING