Yamaha MT-09 2021 Service Manual page 43

1. Meter assembly
2. Handlebar
3. Handlebar switch (left)
4. Clutch cable
5. Headlight control unit coupler (headlight
assembly side)
6. Grip warmer coupler (left) (OPTION)
7. Meter assembly bracket
8. Auxiliary light coupler (auxiliary light side)
9. Auxiliary light coupler (wire harness side)
10. Handlebar switch coupler (right)
11. Handlebar switch lead (left) (to horn)
12. Horn
13. Brake hose
14. Headlight bracket
15. Wire harness
16. Handlebar switch lead (right)
17. Accelerator position sensor coupler
18. Wire harness (to headlight control unit)
19. Grip warmer coupler (right) (OPTION)
20. Auxiliary DC jack coupler
21. Headlight control unit coupler (wire harness
side)
22. Headlight control unit
23. Handlebar switch (right)
24. Meter assembly coupler
25. Handlebar switch lead (left)
26. Front brake light switch coupler (red)
27. Handlebar switch coupler (right) (white)
A. Clamp the handlebar switch lead (right) to the
rounded part of the handlebar. Face the lock-
ing part of the plastic band forward. Face the
end of the plastic band downward.
B. Clamp the handlebar switch lead (left) to the
rounded part of the handlebar. Face the lock-
ing part of the plastic band forward. Face the
end of the plastic band downward.
C. Insert an auxiliary light coupler into the hole
of the meter assembly bracket.
D. Insert the handlebar switch coupler (right)
into the hole of the meter assembly bracket.
E. Route the handlebar switch lead (left) (to
horn) on the rear side of the wire harness.
F. Insert the clamp into the hole of the meter
assembly bracket.
G. Face the terminal of the horn inside.
H. Insert the clamp into the hole of the headlight
bracket.
I. Route the handlebar switch lead (right) on the
rear side of the wire harness (to accelerator
position sensor).
J. Insert an accelerator position sensor coupler
into the hole of the meter assembly bracket.
K. Route the wire harness (to headlight control
unit) on the front side of the handlebar switch
lead (right).
L. Insert the handlebar switch lead (right) into
the hole of the meter assembly bracket.
M. Route the handlebar switch lead (left)
(to horn) on the rear side of the clutch cable.
Insert the handlebar switch lead (left)
(to horn) into the hole of the meter assembly
bracket.
N. Route the handlebar switch lead (left)
(to horn) on the inside of the damper.
O. Do not ride the damper over the meter
assembly bracket.
P. Route the handlebar switch lead (right) on the
inside of the damper.
Q. Pass the handlebar switch lead (right) behind
the wire harness within the range of the fig-
ure.
R. After connecting the front brake light switch
coupler (red) to the handlebar switch coupler
(right), fix it into the hook part of the meter
assembly bracket.
S. After connecting the handlebar switch cou-
pler (right) (white) to the handlebar switch
coupler (right), fix it into the hook part of the
meter assembly bracket.
2-16
CABLE ROUTING