Yamaha MT-09 2021 Service Manual page 75

1. Rear wheel sensor
2. Rear brake hose (hydraulic unit to rear brake
caliper)
3. Clamp
4. Rear brake hose (rear brake master cylinder
to hydraulic unit)
5. Rear fender
6. Frame
7. Brake fluid reservoir hose
8. Rear brake light switch lead
9. Swingarm
10. Rear wheel sensor lead
A. Fasten the white tape portion of the rear
wheel sensor lead with the clamp.
B. Fasten the grommet of the rear wheel sensor
lead with the clamp.
C. Fasten the gray tape portion of the rear brake
light switch lead with the clamp.
D. Installing position of the rear brake hose (rear
brake master cylinder to hydraulic unit).
(70 mm (2.76 in))
E. 45°
F. Route the rear wheel sensor lead on the out-
side of the rear brake hose (hydraulic unit to
rear brake caliper).
G. Outside of the vehicle
H. Fasten the protector of the rear brake hose
with the clamp.
I. The opening of the clamp should face the top.
Make sure the clamp is engaged by 3 or
more notches.
J. Route the rear wheel sensor lead on the out-
side of the rear brake hose (hydraulic unit to
rear brake caliper).
K. The opening of the clamp should face the
down.
L. The opening of the clamp should face the
outside. Make sure the clamp is engaged by
3 or more notches.
M. The opening of the clamp should face the
rear. Make sure the clamp is engaged by 3 or
more notches.
N. Route the rear brake light switch lead on the
outside of the rear brake hose (rear brake
master cylinder to hydraulic unit).
O. Fasten the protector of the brake fluid reser-
voir hose with clamp. The opening of the
clamp should face the front.
P. Fasten the brake fluid reservoir hose and rear
brake hose (rear brake master cylinder to
hydraulic unit) with clamp. The opening of the
clamp should face the down.
2-48
CABLE ROUTING