Yamaha MT-09 2021 Service Manual page 53

1. Shift sensor lead
2. Wire harness
3. Clamp
4. Starter motor lead
5. Gear position sensor coupler
6. Gear position sensor
7. Shift sensor
8. Sidestand switch
9. Sidestand switch lead
10. Fuel tank drain hose
11. O sensor
2
12. Holder
13. Canister breather hose
14. Shift rod joint
15. Locknut
16. Shift arm
17. Shift rod joint and dust cover
18. Wire harness (to gear position sensor)
19. Radiator outlet hose
20. O
sensor lead
2
21. Rear shock absorber hose
A. To fuel pump.
B. Fix the O sensor lead to the rounded part on
2
the radiator outlet hose with a plastic locking
tie.
C. Arrange the sidestand switch lead, canister
breather hose and fuel tank drain hose from
inside of the vehicle in order.
D. The opening of the clamp should face the
right.
E. Arrange the shift sensor lead to the front side.
F. Left side of the vehicle
G. Front of the vehicle
H. Pass the shift sensor lead in front of the shift
rod joint and shift arm.
I. Bend the shift sensor lead upward at the bot-
tom of the sensor side.
J. Fix the shift sensor and its lead to the top part
of the locknut on the shift sensor with the
clamp.
K. Arrange the sidestand switch lead to the
inside of the vehicle.
L. Face the paint mark on the fuel tank drain
hose to the outside and pass it through the
holder.
M. Route the wire harness (to gear position sen-
sor) on the left side of the starter motor lead.
N. Route the O sensor lead on the inside of the
2
radiator outlet hose.
O. Face the locking part of the plastic locking tie
inward. Face the end of the plastic locking tie
downward and cut off the excess.
P. Lower side of the vehicle
Q. For MTN890
R. For MTN890D
S. Route the wire harness (to gear position sen-
sor) on the left side of the rear shock
absorber hose and starter motor lead.
T. Left outside of the vehicle
2-26
CABLE ROUTING