Mitsubishi Electric MELSEC-Q Series User Manual page 153

9 PARAMETER LIST
Item
PLC name settings
Label
Comment
PLC system settings
Low-Speed timer
Timer setting
High-Speed timer
RUN-PAUSE contact
Remote reset
STOP-RUN output mode
Number of vacant slot points
Interrupt counter
System
In Fixed cycle
interrupt
interval
settings
(n: 28 to 31)
Interrupt program/fixed scan
program setting
Module synchronization
PLC RAS settings
WDT
WDT setting
settings
Operation mode at error occurrences
Error check
Constant scan
9 - 3
Table 9.1 Parameter List
Designate the label and comment for the CPU module to be used.
These settings do not affect CPU module operation
Designates the label setting (name and use).
Designates the comment setting.
These are the settings required for using the CPU module.
Default values are available for PLC control.
Designates the low-speed/high-speed timer settings
Designates the contact which controls the CPU's module RUN/PAUSE operation.
Setting of only the PAUSE contact cannot be made. (Setting of the RUN contact or
RUN contact + PAUSE contact can be made.)
Enables/disables the remote reset operation from the GX Developer.
Designates the output(Y) mode at STOP-RUN switching.
Designates the number of vacant slot points in the base/extension base midule.
Designates the interrupt counter "first No."
Specifies time intervals at which to execute interrupt pointers (I28 to I31).
Specifies whether to perform the high-speed execution of an interrupt program.
Specifies whether to bring the start of a CPU module into synchronization with the
start of an intelligent-function module.
These settings are used for the RAS function.
Set the watchdog timer of the CPU module.
Designates the CPU module operation mode to be established when an error is
detected.
Designates whether or not to detect a specified error .
Designates the constant scanning time.
Description
MELSEC-Q
9 - 3