Advertisement
TC32306FTG
[D0] NIR_L2
When to use NIR filter (h'10[D1]NIR_Fil_en = "1") and Delay Detection (h'10[D0]Sel_Det = "0"), set this register "1".
When to use NIR filter (h'10[D1]NIR_Fil_en = "1") and Pulse Count Detection (h'10[D0]Sel_Det = "1"), set this register "0".
6.10.8 h'10 RX Function Settings 2
Table 6-63 Register (h'10)
D7
D6
D5
D4
D3
D2
D1
D0
Name
AutoOffA_
AutoOffB_
USER_
DET_out_
Charge1_en Charge2_en
NIR_Fil_en
Sel_Det
en
en
TEST
cnt_en
Initial
0
1
0
0
0
1
0
0
Type
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
[D7]Charge1_en [Data Comparator Quick Charge 1]
0: Disable / 1: Enable
[D6]Charge2_en [Data Comparator Quick Charge 2]
0: Disable / 1: Enable
[D5]AutoOffA_en [AutoOff Type A]
0: Disable / 1: Enable
Notice: When to use the function of AutoOff Type A with using Preamble Detection, set both Data Comparator Quick Charge 1
and 2 to the status of ON.
[D4] AutoOffB_en [AutoOff Type B]
0: Disable / 1: Enable
[D3]USER_TEST [User Test]
0: Disable / 1: Enable (Internal monitor signals output from DET_TMONI3 / DET_TMONI4 Pin.)
[D2]Det_out_cnt_en [DET_out Signal Output Control]
0: Disable / 1: Enable
[D1]NIR_Fil_en [NIR (Near Interference Rejection) Filter Control]
When to use FSK Demodulation (h'0A[D4]FSK_ASK = "0"), this setting is valid.
0: Disable / 1: Enable
[D0] Sel_Det [IF Detection Select]
When to use FSK Demodulation (h'0A[D4]FSK_ASK = "0"), this setting is valid.
0: Delay Detection / 1: Pulse Count Detection
63
2015-10-01
Advertisement
