Table of Contents
Advertisement
41
Troubleshooting
When a problem occurred during operation, refer to this section. This section de-
scribes assumed problems and how to solve them.
T-1
A transmission adaptor connection error was occurred.
Cause
Driver is not installed.
Power is not supplied to the transmission
adaptor.
Countermeasure
To use this product, install necessary drivers/software for this product following
the ***QUICK START*** enclosed with this product.
Make sure that USB equipment (USB hub, etc.) that this product is connected
to, is not overloaded (power supplied thru the interface does not exceeds the
maximum limit).
T-2
Data is not displayed on the monitor screen (System List screen or Detail Diagram
screen, etc.)
Cause
Data cannot be displayed because the unit data which is the display objective was
not received.
Countermeasure
Change the setting by Data Recording Setting. For details, refer to "par. (-13-1
Data Recording Setting".
T-3
During scanning, PC power was dropped by a power failure or erroneous operation
and operation became unstable.
Countermeasure
At a power failure, incomplete data remains and operation may be performed with
this incomplete data at the next starting. Repeat scanning. When the power was in-
terrupted during another operation, the operation may return to normal by the same
operation after resetting.
Copyright© 2009-2017 Fujitsu General Limited. All rights reserved.
137
Advertisement
Table of Contents
