Table of Contents
Advertisement
T-(
Air conditioner is not controlled in R.C. group units.
Cause
R.C group data cannot be acquired.
Countermeasure
Repeat scanning by detailed information scanning setting.
T-(
Refrigerant circuit diagram is not displayed for outdoor/indoor unit in the Detail Dia-
gram screen.
(Message "Cannot display refrigerant circuit diagram" is displayed).
Cause
Model name was not acquired from indoor/outdoor unit (V-II/J-II/J-IIS/JIII/JIIIL/VR-
II/V-III series).
Countermeasure
Perform scan again (Refer to "par. 3-2-( Scanning Setting").
After scanning, check that the model name is displayed in the System List
screen.
If the name is not displayed in the System List screen, enter the correct model
name for the unit in the Name master database file (Refer to "par. 3-2-4 Name
Master Database file selection screen") and select "re-scanning" from the right-
circle menu in the task tray.
When requested for the Name master database file, specify the file, but the fol-
lowing scan may be cancelled.
T-6
Troubleshooting for VRF is not displayed on 'Adobe Acrobat Reader'.
Countermeasure
Start the 'Adobe Acrobat Reader'.
Select [Edit] menu → [Preferences...] → [Security(Enhanced)]
Remove the check mark of the 'Enable Protected Mode at startup'.
Q-1
Can the Service Tool be restarted by installing it on the same PC as the System Con-
troller or other Software tool and using the same transmission adaptor?
Answer
The Service Tool can be installed on the same PC, but simultaneous operation is
outside the warranty. Also, each application cannot simultaneously share 1 trans-
mission adaptor.
138
Copyright© 2009-2017 Fujitsu General Limited. All rights reserved.
Advertisement
Table of Contents
