Fujitsu AIRSTAGE UTY-ASGXZ1 Operating Manual page 34

Table of Contents

Analyzer type selection tab

Select the type of network topology analyzer from either "Type A" or "Type B".

"Type A" is used for V-II and J-II series, and "Type B" for VR-II, J-IIS, J-III, J-IIIL,

V-III or later series.

Note

If the analyzer type is incorrect, the correct results will not be displayed.

Adaptor selection

Selects the transmission adaptor which acquires the connection data.

Refrigerant system selection

Selects the intended refrigerant system address. The type is selected from all refriger-

ant systems or arbitrary refrigerant system range.

Refrigerant system range input

Enters the intended refrigerant of this function over the 00 to 99 range when "Ref. No."

is selected at step

"Perform System Initialization" check

When checked, the verification screen is displayed. When the [Yes] button is clicked,

all the units in the VRF system stop.

When the [No] button is checked, check mark is removed.

Start button

Starts this processing.

It takes up to 1 hour from start to the end of this process.

Note

However, this process time may be shorten depending on the setting of

Progress bar

Displays the progress of this processing.

Note

When Type B is used, the progress bar display shows the 1000 units of the maxi-

mum number of responding units as 100%. Consequently, check the progress

state by considering that the last display position depends on the number of

responding units.

Table of Contents