Silvercrest SCNM 100 A1 Operating And Safety Instructions Manual page 11

Needle up/down position button
a. Use the Needle up/down position button to decide whether
the needle should stop at the highest or lowest position (in the
fabric) when stopping sewing.
NOTE
If you press the Needle up/down position button during sew-
ing, the sewing machine stops automatically.
Press the Needle up/down position button so that the arrow
points upwards; then the device stops with the needle in the high-
est position.
Press the Needle up/down position button so that the arrow
points downwards; then the device stops with the needle in the
lowest position.
b. Switching the buzzer off/on:
Press the Needle up/down position button for about 3 seconds
until the device beeps to confirm that the sound has been turned
off.
Press the Needle up/down position button for about 3 seconds
until the device signals with two short beeps that the sound is on.
Cursor buttons
Use the right/left button to move the cursor in the LCD screen to
the item you want to change (stitch number, stitch length or stitch
width).
Value setting buttons
Use the up/down button to change the values of the stitch num-
ber, stitch length and stitch width fields in the LCD screen.
Speed adjustment slider
The sewing speed can be adjusted with the speed adjustment
slider.
Slide the lever to the right to increase the sewing speed.
Slide the lever to the left to reduce the sewing speed.
NOTE
The sewing speed can also be adjusted with the foot controller.
The speed adjustment slider also limits the maximum sewing
speed that can be achieved via the foot controller.
Introduction
EN 11