Maintenance; Clean The Machine Surface; Cleaning The Looper, Bobbin Case And Feed Dog; Storage - Silvercrest SCNM 100 A1 Operating And Safety Instructions Manual

WARNING!
Disconnect the power cord from the wall socket before carrying out any maintenance, otherwise injury or electrical shock may result.

Clean the machine surface

NOTE
Do not use any organic solvents or detergents.
Clean the sewing machine if the surface of the sewing machine is dirty:
3. Wipe the sewing machine with a light cloth dipped in mild detergent and wrung out thoroughly.
4. After cleaning the sewing machine once in this way, wipe the surface again with a dry cloth.

Cleaning the looper, bobbin case and feed dog

If lint and bits of thread accumulate in the looper, this will interfere with the smooth operation of the machine. Check regularly and clean the stitching
mechanism when necessary.
2
3
1

Storage

Clean the looper, bobbin case and feed dog:
1. Remove the needle, presser foot and presser foot holder.
2. Remove the bobbin cover
2
3. Remove the screws on the needle plate
4. Remove the needle plate
5. Clean the looper, feed dog and bobbin case with the brush side of the
supplied seam ripper/brush (i).
NOTE
And also use a soft and dry cloth to clean them.
6. Follow steps 1 to 4 in reverse order and install the removed parts.
• Always remove the power plug from the socket when not using the sewing
machine.
• Use the dust cover(s) provided.
• Store the sewing machine in a dry location which children cannot access.
• If the sewing machine is not used for an extended period, it should be pro-
tected from excessive dust, dirt or moisture.

Maintenance

①
and bobbin.
②
with the L-screwdriver (l).
③
.
EN 57