Sewing A Buttonhole On Non-Stretch Fabrics - Silvercrest SCNM 100 A1 Operating And Safety Instructions Manual

Sewing applications
1
44 EN
1
2
v Sewing a buttonhole on non-stretch fab-
rics:
1. Mark the positions of the buttonhole on the fabric.
NOTE
The maximum buttonhole length is 3 cm. (Total of diameter +
thickness of button). The size of the buttonhole is determined by
the button inserted in the button holder plate.
2. Pull the button holder plate to the back, and place the
button in it. Push back the button holder plate against the
button to hold it tight.
Attach the buttonhole foot to the sewing machine.
NOTE
Pull the thread through the hole in the presser foot so that it is
under the presser foot.
3. Place the fabric under the presser foot so that the center
①
mark on the presser foot is aligned with the drawn
buttonhole line. Select the buttonhole stitch. Adjust the stitch
width and the stitch length to the desired width and density.
4. Pull down the buttonhole lever
NOTE
②
It must be behind the holder
5. Slightly hold the end of the upper thread and start sewing.
Hold both threads tightly.
NOTE
Gently feed the fabric by hand. Before stopping, the sewing
machine will automatically sew a reinforcement stitch after the
buttonhole is sewn.
6. Raise the presser foot and cut the thread.
NOTE
To sew over the same buttonhole again, raise the presser foot. (It
returns to the starting position.)
①
to the very bottom.
on the buttonhole foot.