Table of Contents
Advertisement
APPENDICES
Appendix 1
This chapter describes parameters set for programmable controller systems.
(1) Parameter types
The following parameters are provided for CPU modules.
• PLC parameters (
These parameters are set when a CPU module is used stand alone in a system.
• Network parameters (
These parameters are set when a CPU module is used in combination with network modules, such as CC-
Link IE Controller Network modules, MELSECNET/H modules, Ethernet modules, and CC-Link modules.
• Remote password (
This parameter is set when the remote password function of Built-in Ethernet port QCPUs, Ethernet
modules, serial communication modules, or modem interface modules is used.
(2) Parameter setting method
Use a programming tool.
For the setting, refer to the following.
Operating manual for the programming tool used
The setting cannot be done in the grayed-out area (not selectable) of the screen because the function of the area is not
available.
Remark
Each parameter number shown in the tables in this chapter is stored in the special register (SD16 to SD26) when an error
occurs in parameter setting.
Identify the parameter error location from the parameter number.
430
Parameters
Page 437, Appendix 1.2)
Page 457, Appendix 1.3)
Page 463, Appendix 1.4)
Advertisement
Table of Contents
