Canon CXDI-80C Service Manual page 54

7.1.2 Connecting the infrared data communication unit
1) Turn on the power of the image capture computer, and install the drivers from the CD supplied when
the infrared data communication unit was purchased.
• For the driver installation procedure, refer to the Manual and Quick Guide contained on the supplied
CD.
2) Connect the infrared data communication unit to the USB connector on the image capture computer.
Infrared data communication unit
Image Capture Computer
3) Turn on the power of the image capture computer, and check that the link controller has started up.
• If "Use LINK Module" of the access point setting tool is ON, the link controller will start up
automatically when the operating system is started. (An icon is displayed at the bottom right of the
task bar.)
• For details, refer to "Appendix6 AP/LINK Configuration Tool" in Chapter 4. Setting reference of
the CXDI Control Software NE V.1.40 Service Manual.
2. Installation procedures
- 21 -